To complete the installation you will need:

- A treo 650 or 700 phone.

- Torx #5 screwdriver.

- A sewing needle.

- A short antenna from TreoAntenna.com.

Start by removing the rubber plug at the base of the antenna.

Use the needle to gently peel off the warranty sticker. Take note that on the Treo 700 it is going to be hard to remove the sticker and you might destroy it in the process.

Save the sticker so you can install it back in later.

TreoAntenna.com is not responsible for any warranty issues you might have once you remove the warranty sticker.

Using the Torx #5 screwdriver, remove the antenna screw.

Pull the original antenna out of the case. On the Treo 700 you might need to split the case a bit to pull the antenna out.

Push the short antenna in the case.

Put the antenna screw back in.

Install the warranty sticker.

And install the rubber plug.

Enjoy your new short antenna.